Cisco Ip Phone 8800 Series Multiplatform Phones Administration Guide - Cisco 8851 Administration Manual

Cisco IP Phone Web Page
Parameter
Conference Package
RFC 2543 Call Hold
Random REG CID on Reboot
SIP TCP Port Min
SIP TCP Port Max
Caller ID Header
Hold Target Before Refer
Dialog SDP Enable
Keep Referee When Refer Failed
Display Diversion Info
Display Anonymous From Header

Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide

222
Description
Enables support for the BroadSoft Conference Package that enables
users to start a conference call by clicking a button in an external
application.
Default: No
If set to yes, unit includes c=0.0.0.0 syntax in SDP when sending a SIP
re-INVITE to the peer to hold the call. If set to no, unit will not include
the c=0.0.0.0 syntax in the SDP. The unit will always include a=sendonly
syntax in the SDP in either case.
Default: Yes
If set to yes, the phone uses a different random call-ID for registration
after the next software reboot. If set to no, the Cisco IP phone tries to
use the same call-ID for registration after the next software reboot. The
Cisco IP phone always uses a new random Call-ID for registration after
a power-cycle, regardless of this setting.
Default: No.
Specifies the lowest TCP port number that can be used for SIP sessions.
Default: 5060
Specifies the highest TCP port number that can be used for SIP sessions.
Default: 5080
Provides the option to take the caller ID from PAID-RPID-FROM,
PAID-FROM, RPID-PAID-FROM, RPID-FROM, or FROM header.
Default: PAID-RPID-FROM
Controls whether to hold call leg with transfer target before sending
REFER to the transferee when initiating a fully-attended call transfer
(where the transfer target has answered).
Default: No
When enabled and the Notify message body is too big causing
fragmentation, the Notify message xml dialog is simplified; Session
Description Protocol (SDP) is not included in the dialog xml content.
If set to yes, it configures the phone to immediately handle NOTIFY
sipfrag messages.
Display the Diversion info included in SIP message on LCD or not.
Show the caller ID from the SIP INVITE message "From" header when
set to Yes, even if the call is an anonymous call. When the parameter
is set to no, the phone displays "Anonymous Caller" as the caller ID.