Cisco Ip Phone 8800 Series Multiplatform Phones Administration Guide - Cisco 8851 Administration Manual

Non-Lockable Wall Mount Components for Phone with Key Expansion Module
Before You Begin
Obtain two Phillips head screwdrivers or other similar devices that have a diameter of 5 millimeters or 3/16ths
of an inch.
Procedure
Step 1 Insert a screw driver or other device into the left and right holes in the phone mounting plate. Insert to a depth
of about 3/4 of an inch or 2 centimeters.
Step 2 Press firmly inwards to disengage the tabs.
Figure 10: Disengage Tabs
Step 3 Lift the phone to release it from the wall bracket. Pull the phone toward you.
Non-Lockable Wall Mount Components for Phone with Key Expansion Module
This section describes how to install the Cisco IP Phone 8800 Series Wall Mount Kit with Single KEM on a
phone when the phone is connected to a Key Expansion Module.
The following figure shows the wall mount kit installed on the phone.

Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide

110