Connecting The Receiver - Cisco IPN330HD Installation Manual

Connecting the Receiver

To connect your receiver to your network and home entertainment devices, complete these steps.
Because the connections
for a high-defi nition (HD)
or standard-defi nition (SD)
TV are different, you must
1
determine if your TV is HD
or SD. Your TV must
receive HD signals for
you to enjoy the benefi ts
of HDTV. Refer to the manual that came with your TV for more information.
See page 26 for more information on picture formats.
Make one of the following connections for your home network:
• If your home network uses coaxial cable, use the TO WALL connector on the
2
• If your home network uses twisted pair cable (phoneline wiring), use the TO
• If your home network uses Ethernet (CAT-5) cable, use the NETWORK connector
Make the connections for your TV, VCR, and DVD recorder as follows:
• If you are using an HDTV, see page 12 and the connection diagrams in this
3
• If you are using a standard-defi nition TV, see page 13 and the connection
• If you want to record some programs on VCR tape or DVD, see page 14

Identify the additional consumer
electronic devices you will
connect to the receiver and TV.
4
See pages 15 through 23 and
refer to the owner's manual for
the device.
Plug the receiver and the TV into an AC power source that is not controlled by a
switch. For further instructions on completing your setup, refer to the Feature
Guide available from your service provider.
5
10
receiver. See page 11.
WALL connector on the receiver and an adapter that converts twisted pair to
coaxial. See page 11.
on the receiver. See page 11.
manual.
diagrams in this manual.
and the connection diagrams in this manual.
16
9
VCR
or 3
DVD
Home Theater
4
Other