Starting Up The Replacement Ssd - Siemens SINUMERIK 840D sl Commissioning Manual

Backing up and restoring data

5.11 Starting up the replacement SSD

5.11 Starting up the replacement SSD
The replacement SSD for use with PCU 50.5 is delivered with the Service Center installed
and network settings as delivered with the delivery condition (Page 9) of the PCU 50.5.
When you have replaced the SSD, use the Service Center to read in a disk image.
Precondition
● The replacement SSD is installed in the PCU 50.5
● If the network settings of the delivery condition (Page 9) are not the same as those of
your system network or company network, disconnect the PCU 50.5 from the network, if
necessary.
Further information
Information about replacing and installing an SSD on the PCU is provided in the Operator
Components and Networking Manual.
Procedure
Proceed as follows to read a disk image onto a replaced SSD:
1. Connect a PG/PC containing the required disk image.
2. Start the ServiceCenter and select "Disk Restore."
3. Select the disk image and confirm your settings with "Restore."
Note
Troubleshooting if reading in of the disk image fails
If reading in of the data is interrupted, the PCU will have no executable system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in
again.
84
See also: Restoring a disk image (Page 68)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
PCU Base Software (IM10)