Huawei NetCol8000-E220 User Manual page 221

NetCol8000-E220 Modular Indirect Evaporative
Cooling System
User Manual
2.
3.
4.
5.
Step 8 Secure the compressor bracket to the cabinet interior using a 13# socket wrench.
Step 9 Install the electric heating belt and compressor ground cable, remove the
connection box cover, and reinstall the cover after the compressor cables are
connected.
Issue 06 (2020-08-19)
NO TICE
After removing the valve, seal the suction vent immediately to ensure that the
system is clean and moisture does not enter the pipe.
Heat the air intake angle valve joints using a heat gun for 10 minutes. Secure
the angle nut and pipe nut on the air intake side, using two 30# adjustable
wrenches respectively. Then loosen the adjustable nut using a 30# adjustable
wrench to separate the pipe from the angle valve. After removing the valve,
seal the suction vent immediately.
Remove the two M8 screws below the compressor bracket, using a 13# socket
wrench (or solid wrench).
NO TICE
Do not move the compressor by moving its air exhaust vent.
Remove the four nut washers and spring washers that secure the compressor
and the bracket using a 13# socket wrench (or solid wrench), and remove the
compressor.
Figure 6-8 Removing a compressor bracket
Secure the new compressor to the bracket again using a solid wrench.
Copyright © Huawei Technologies Co., Ltd.
6 System Operation and Maintenance
212