ABB ACSM1 Firmware Manual page 94

94
(0) DONE
(1) SAVE
16.09 USER SET SEL
Enables the save and restoration of up to four custom sets of parameter settings.
The set that was in use before powering down the drive is in use after the next power-up.
Note: Any parameter changes made after loading a set are not automatically stored – they must be
saved using this parameter.
(1) NO REQUEST
(2) LOAD SET 1
(3) LOAD SET 2
(4) LOAD SET 3
(5) LOAD SET 4
(6) SAVE SET 1
(7) SAVE SET 2
(8) SAVE SET 3
(9) SAVE SET 4
(10) IO MODE
16.10 USER SET LOG
Shows the status of the user parameter sets (see parameter
N/A
(1) LOADING
(2) SAVING
(4) FAULTED
(8) SET1 IO ACT
(16) SET2 IO ACT
(32) SET3 IO ACT
(64) SET4 IO ACT
(128) SET1 PAR ACT
(256) SET2 PAR ACT
Parameters and firmware blocks
Save completed.
Save in progress.
FW block: None
Load or save operation complete; normal operation.
Load user parameter set 1.
Load user parameter set 2.
Load user parameter set 3.
Load user parameter set 4.
Save user parameter set 1.
Save user parameter set 2.
Save user parameter set 3.
Save user parameter set 4.
Load user parameter set using parameters
FW block: None
No user sets have been saved.
A user set is being loaded.
A user set is being saved.
Invalid or empty parameter set.
User parameter set 1 has been selected by parameters
16.12.
User parameter set 2 has been selected by parameters
16.12.
User parameter set 3 has been selected by parameters
16.12.
User parameter set 4 has been selected by parameters
16.12.
User parameter set 1 has been loaded using parameter 16.09.
User parameter set 2 has been loaded using parameter 16.09.
16.11 and 16.12.
16.09 USER SET SEL). Read-only.
16.11 and
16.11 and
16.11 and
16.11 and