ABB ACSM1 Firmware Manual page 74

74
Block outputs located in other
parameter groups
10.01 EXT1 START FUNC
Selects the source for the start and stop control in external control location EXT1.
Note: This parameter cannot be changed while the drive is running.
(0) NOT SEL
(1) IN1
(2) 3-WIRE
(3) FBA
(4) D2D
(5) IN1F IN2R
(6) IN1S IN2DIR
10.02 EXT1 START IN1
Selects the source 1 for the start and stop commands in external control location EXT1. See
parameter
Note: This parameter cannot be changed while the drive is running.
Parameters and firmware blocks
2.18 D2D FOLLOWER CW
6.01 STATUS WORD 1
6.02 STATUS WORD 2
6.03 SPEED CTRL STAT
6.05 LIMIT WORD 1
6.07 TORQ LIM STATUS
Outputs 6.09...6.11 are not used with the Speed and Torque Control
Program.
FW block:
No source selected.
Source of the start and stop commands are selected by parameter
10.02 EXT1 START
Par. 10.02
Source of the start and stop commands are selected by parameters
10.02 EXT1 START IN1
controlled as follows:
Par.
Start and stop control from the source selected by parameter
CW USED.
Start and stop control from another drive via D2D Control Word.
The source selected by
signal, the source selected by
start signal.
Par.
The source selected by
(0 = stop, 1 = start), the source selected by
the direction signal (0 = forward, 1 = reverse).
FW block:
10.01 EXT1 START FUNC
(page 62)
(page 65)
(page 66)
(page 67)
(page 67)
(page 68)
DRIVE LOGIC (see above)
IN1. The start/stop is controlled as follows:
Command
0 -> 1 Start
1 -> 0 Stop
and 10.03 EXT1 START
10.02 Par. 10.03 Command
0 -> 1 1
Any 1 -> 0
Any 0
10.02 EXT1 START IN1
10.02 Par. 10.03
0 0
1 0
0 1
1 1
10.02 EXT1 START IN1
DRIVE LOGIC (see above)
selections (1) IN1 and
IN2. The start/stop is
Start
Stop
Stop
is the forward start
10.03 EXT1 START IN2
Command
Stop
Start forward
Start reverse
Stop
is the start signal
10.03 EXT1 START IN2
(2) 3-WIRE.
10.13 FB
is the reverse
is