Oil Level Indicator And Tube Replacement Removal Procedure - Suzuki XL7 2007 Service Manual

1E-5 Engine Lubrication System:
Checks
Black Light and Dye Method
Possible Causes for Leaks
Oil Level Indicator and Tube Replacement
Removal Procedure
1. Turn the ignition OFF.
2. Remove the oil level indicator from the oil level
indicator tube.
3. Remove the oil level indicator tube bolt.
4. Remove the oil level indicator tube up through the
exhaust manifold.
5. If you are replacing only the oil level indicator tube
seal, remove and discard the old seal.
1. A dye and light kit is available for finding leaks. Use the J 28428-E High-
Intensity Black Light Kit or equivalent. Refer to the manufacturer's
instructions when using the tool.
2. Visually inspect the suspected area. Use a small mirror to assist in looking
at hard to see areas.
3. See possible causes for leaks.
Check for the following conditions:
• Higher than recommended fluid levels
• Higher than recommended fluid pressures
• Plugged or malfunctioning fluid filters or pressure bypass valves
• Plugged or malfunctioning engine ventilation system
• Improperly tightened or damaged fasteners
• Cracked or porous components
• Improper sealants or gaskets where required
• Improper sealant or gasket installation
• Damaged or worn gaskets or seals
• Damaged or worn sealing surfaces
Repair Instructions
Installation Procedure
1. Install a new seal on the oil level indicator tube.
2. Install the oil level indicator tube.
3. Install the oil level indicator tube bolt.
4. Install the oil level indicator in the oil level indicator
Action
CAUTION
!
Refer to "Fastener Notice: ".
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
tube.