Ignition Coil Replacement - Bank 1 - Suzuki XL7 2007 Service Manual

Ignition Coil Replacement - Bank 1

Removal Procedure
1. Remove the fuel injector sight shield. Refer to "Fuel
Injector Sight Shield Replacement: ".
2. Disconnect the engine wiring harness electrical
connector(s) (1) from the ignition coil(s).
3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).
Repair Instructions
Installation Procedure
1. Install the ignition coil(s).
!
Refer to "Fastener Notice: ".
2. Install the ignition coil bolt(s).
Tightening torque
Tighten the bolt(s) to 10 N⋅m (89 lb in).
3. Connect the engine wiring harness electrical
connector(s) (1) to the ignition coil(s).
4. Install the fuel injector sight shield. Refer to "Fuel
Injector Sight Shield Replacement: ".
CAUTION
Ignition System: 1H-3