1G-48 Fuel System:
Filler Tube Replacement
Removal Procedure
NOTE
Replacement fuel filler tube hoses do not
come equipped with hose clamps. Obtain
replacement hose clamps prior to beginning
this service procedure.
WARNING
!
Do not allow smoking or the use of open
flames in the area where work on the fuel or
EVAP system is taking place. Anytime work is
being done on the fuel system, disconnect
the negative battery cable, except for those
tests where battery voltage is required.
1. Ensure that the fuel level in the tank is less than 1/4
full. If necessary, drain the fuel tank to at least this
level. Refer to "Fuel Tank Draining".
2. Remove the fuel fill cap.
3. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
4. Remove the right rear wheel and tire. Refer to "Tire
and Wheel Removal and Installation: ".
5. Remove the right rear wheelhouse inner liner. Refer
to "Rear Wheelhouse Liner Panel Replacement: ".
6. Loosen the fuel fill tube hose clamp.
7. Disconnect the fuel fill tube, the fuel fill vent tube,
and the fresh air hose from the fuel tank.
8. Remove the fuel fill tube bracket bolts (2).
9. Remove the fuel fill tube (1) from the vehicle.
10. Remove the closeout grommet.