Suzuki XL7 2007 Service Manual page 1042

2C-15 Rear Suspension:
5. Tighten the upper control arm to support bolt.
Tightening torque
Tighten the upper control arm to support bolt to
164 N⋅m (121 lb ft).
6. Install the rear brake hose routing nut and bolt.
Tightening torque
Tighten the rear brake hose bolt and nut to 12
N⋅m (106 lb in).
7. Connect the ABS brake wiring harness to the upper
control arm.
8. Install the rear tire and wheel assembly. Refer to
"Tire and Wheel Removal and Installation: ".
9. Lower the vehicle.
10. Check the rear alignment. Refer to "Measuring
Wheel Alignment: ".
Rear Axle Lower Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. Remove the rear tire and wheel assembly. Refer to
"Tire and Wheel Removal and Installation: ".
3. Remove the stabilizer shaft link. Refer to "Stabilizer
Shaft Link Replacement".
4. Position a jackstand underneath the lower control
arm.
5. Raise the jackstand slightly to compress the coil
spring.
6. Remove the lower shock bolt and nut.
7. Loosen the lower control arm to support frame nut
and bolt.
8. Remove the lower control arm to knuckle nut and
bolt.
9. Slowly lower the control arm in order to unload the
coil spring.
10. Remove the coil spring.
11. Remove the jackstand.