7. Remove the wheel bearing from the knuckle.
Installation Procedure
1. Position the wheel bearing to the knuckle.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the 4 wheel bearing bolts.
Tightening torque
Tighten the 4 wheel bearing bolts to 125 N⋅m (92
lb ft).
3. If equipped with AWD, install the rear wheel
driveshaft nut.
Tightening torque
Tighten the rear wheel driveshaft nut to 70 N⋅m
(52 lb ft).
4. Install the wheel speed sensor. Refer to "Rear Wheel
Speed Sensor Replacement: ".
5. Install the brake rotor. Refer to "Rear Brake Rotor
Replacement: ".
6. Install the rear tire and wheel assembly. Refer to
"Tire and Wheel Removal and Installation: ".
7. Lower the vehicle.
Rear Suspension:
2C-12