Suzuki XL7 2007 Service Manual page 427

4. Place the engine front cover onto the EN 46109 and
slide into position.
5. Remove the EN 46109 from the cylinder block.
6. Hand start all the front cover bolts.
CAUTION
!
Refer to "Fastener Notice: ".
7. Tighten the engine front cover bolts in the sequence
shown.
Tightening torque
Tighten the engine front cover bolts in sequence
to 23 N⋅m (17 lb ft).
8. Install the engine oil pan. Refer to "Oil Pan
Replacement: ".
9. Install the camshaft position actuator solenoid valves
from the front cover. Refer to "Camshaft Position
Actuator Solenoid Valve Solenoid Replacement -
Bank 1 (Right Side) Intake: ", "Camshaft Position
Actuator Solenoid Valve Solenoid Replacement -
Bank 1 (Right Side) Exhaust: ", "Camshaft Position
Actuator Solenoid Valve Solenoid Replacement -
Bank 2 (Left Side) Intake: ", and "Camshaft Position
Actuator Solenoid Valve Solenoid Replacement -
Bank 2 (Left Side) Exhaust: ".
10. Install the camshaft position actuator valves from the
front cover. Refer to "Camshaft Position Sensor
Replacement - Bank 2 (Left Side) Exhaust: ",
"Camshaft Position Sensor Replacement - Bank 2
(Left Side) Intake: ", "Camshaft Position Sensor
Replacement - Bank 1 (Right Side) Exhaust: " and
"Camshaft Position Sensor Replacement - Bank 1
(Right Side) Intake: ".
11. Install the crankshaft balancer. Refer to "Crankshaft
Balancer Replacement".
12. Install the power steering pump and position aside.
Refer to "Power Steering Pump Replacement: ".
13. Install the water pump. Refer to "Water Pump
Replacement: ".
14. Install the water outlet housing assembly. Refer to
"Water Outlet Housing Replacement: ".
15. Install the drive belt tensioner. Refer to "Drive Belt
Tensioner Replacement".
16. Install the camshaft covers. Refer to "Camshaft
Cover Replacement - Left Side" and "Camshaft
Cover Replacement - Right Side".
17. Install the lower intake manifold. Refer to "Lower
Intake Manifold Replacement".
18. Refill the engine coolant. Refer to "Draining and
Filling Cooling System (LY7 GE 47716 Fill): "
"Draining and Filling Cooling System (LY7 Static Fill):
".
Engine Mechanical: 1D-87