1C-20 Engine Electrical Devices:
Crankshaft Position Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
2. If equipped with all wheel drive (AWD), remove the
transfer case. Refer to "Transfer Case Assembly
Replacement: ".
3. Disconnect the engine wiring harness electrical
connector (2) from the crankshaft position (CKP)
sensor.
4. Remove the crankshaft sensor bolt.
5. Remove the crankshaft sensor.
Installation Procedure
1. Install the crankshaft position sensor.
CAUTION
!
Refer to "Fastener Notice: ".
2. Install the crankshaft position sensor bolt.
Tightening torque
Tighten the bolt to 10 N⋅m (89 lb in).
3. Connect the engine wiring harness electrical
connector to the CKP sensor.
4. If equipped with all AWD, install the transfer case.
Refer to"Transfer Case Assembly Replacement: ".
5. Lower the vehicle.