Table of Contents
Advertisement
8. Loosen the battery negative cable terminal bolt.
9. Remove the battery negative cable from the battery.
Installation Procedure
CAUTION
!
Refer to "Fastener Notice: ".
NOTE
Clean any existing corrosion from the battery
terminal bolt flange and the battery cable
end.
1. Install the battery negative cable to the battery.
Tightening torque
Tighten the battery negative cable terminal bolt
to 17 N⋅m (13 lb ft).
2. Insert the battery box cover (3) into the retaining (2).
3. Lock the side snap retainers (1).
4. Grasp the ECM retainer and slide the retainer
forward until the retainer locks against the 4 clips on
the battery cover.
5. Program all of the customer's radio station presets
and set the radio clock to the current time.
Charging System:
1J-44
Advertisement
Table of Contents
Troubleshooting
