Table of Contents
Advertisement
Stabilizer Shaft Replacement
Removal Procedure
1. Position the front wheels in the straight ahead
position.
2. Raise and support the vehicle. Refer to "Lifting and
Jacking the Vehicle: ".
3. Remove the front tire and wheels. Refer to "Tire and
Wheel Removal and Installation: ".
4. Remove the stabilizer shaft link ball stud from the
stabilizer shaft. Refer to "Stabilizer Shaft Link
Replacement".
NOTE
In the following service procedure, it is not
necessary to completely remove the outer tie
rod end from the steering rack. Relocate the
outer tie rod end to the side and support if
necessary.
5. Remove the left and right outer tie rods from the
knuckle. Refer to "Rack and Pinion Outer Tie Rod
End Replacement: ".
6. Rotate the left and right steering knuckle all the way
forward.
7. Remove the stabilizer shaft clamp to cradle bolts.
8. Remove the stabilizer shaft clamps and bushings
from the stabilizer bar.
NOTE
Take care not to catch the transmission shift
cable or left wheel house plastic trim when
removing the stabilizer bar.
NOTE
It may be necessary to rotate the stabilizer
shaft 180° while removing it from the vehicle.
9. Remove the stabilizer shaft from the vehicle through
the left wheel opening.
Front Suspension:
2B-9
Advertisement
Table of Contents
Troubleshooting
