1C-34 Engine Electrical Devices:
4. Engine Oil Life Remaining—When available, use a
scan tool to reset the Engine Oil Life Remaining
back to the original percentage recorded before the
module was replaced.
5. Transmission Fluid Life Remaining—When
available, use the scan tool to reset the
Transmission Fluid Life Remaining back to the
original percentage recorded before the module was
replaced.
Fastener Tightening Specifications - Engine Controls - 3.6L (LY7)
Accelerator Pedal Position (APP) Sensor Bolt
Camshaft Position (CMP) Actuator Solenoid Valve Bolt
Camshaft Position (CMP) Sensor Bolt
Crankshaft Position (CKP) Sensor Bolt
Engine Coolant Temperature (ECT) Sensor
Heated Oxygen Sensor (HO2S)
Ignition Coil Bolt
Knock Sensor Bolt
Mass Air Flow (MAF)/Intake Air Temperature Sensor Screw
Rear Exhaust Manifold Heat Shield Bolt
Rear Drive Module Propeller Shaft Guard Bolt
Special Tools - Engine Controls - 3.6L (LY7)
Illustration
Specifications
Application
Special Tools and Equipment
Tool Number/Description
J 35616
GM-Approved Terminal
Test Kit
ECM Reprogramming
• If the ECM needs to be reprogrammed, refer to
"Service Programming System (SPS): ".
• Engine Oil Life Remaining—When available, use a
scan tool to reset the Engine Oil Life Remaining back
to the original percentage recorded before the module
was reprogrammed.
Setup for Component Replacement
The replacement of some components will require a
setup procedure for complete repair.
If any of the following components are replaced, an Idle
Learn Procedure must be performed. Refer to "Idle
Learn: " in Engine Controls - 3.6L (LY7).
• Throttle body assembly
• ECM
Specification
Metric
25 N⋅m
10 N⋅m
10 N⋅m
10 N⋅m
22 N⋅m
42 N⋅m
10 N⋅m
23 N⋅m
4 N⋅m
50 N⋅m
25 N⋅m
English
18 lb ft
89 lb in
89 lb in
89 lb in
16 lb ft
31 lb ft
89 lb in
17 lb ft
35 lb in
37 lb ft
18 lb ft