Camshaft Position Actuator Installation - Right Side Intake - Suzuki XL7 2007 Service Manual

1D-272 Engine Mechanical:
CAUTION
!
Refer to "Fastener Notice: ".
12. Tighten the camshaft bearing cap bolts in the
sequence shown.
Tightening torque
Tighten the camshaft bearing cap bolts in
sequence to 10 N⋅m (89 lb in).
13. Loosen the center intake camshaft bearing cap bolts
1, 2 and the center exhaust camshaft bearing cap
bolts 3, 4.
14. Retighten the center camshaft bearing cap bolts 1, 2,
3, 4.
Tightening torque
Retighten the camshaft bearing cap bolts to 10
N⋅m (89 lb in).
Reference: "Camshaft Position Actuator Installation -
Left Side Intake (Third Design): ".
Reference: "Camshaft Position Actuator Installation -
Left Side Intake (Fourth Design): ".
Camshaft Position Actuator Installation -
Right Side Intake (Third Design)
Reference: "Camshaft Timing Drive Components
Cleaning and Inspection (Third Design): ".
1. Ensure the proper camshaft position actuator is
installed. Observe the body of the camshaft position
actuator for the "IN" marking (3). The marking is for
an intake camshaft position actuator.
2. Ensure the proper timing mark is used. Observe the
outer ring of the camshaft position actuator for the
triangle marking (2). The marking is for alignment to
the highlighted timing chain link on the right side of
the engine.
CAUTION
!
Refer to "Torque Reaction Against Timing
Drive Chain Notice".
3. Use an open wrench on the hex cast into the
camshaft in order to prevent camshaft rotation when
tightening the camshaft position actuator bolt.