Table of Contents
Advertisement
1D-234 Engine Mechanical:
11. Install the insert (2) into the tapped hole by hand
only.
NOTE
If the insert will not thread down until the
flange contacts the surface of the base
material remove the insert immediately with a
screw extracting tool and inspect the tapped
hole for any remaining chips and/or improper
tapping.
12. Install the insert until the flange (2) of the insert
contacts the surface of the base material.
NOTE
The driver installation tool will tighten up
before screwing completely through the
insert. This is acceptable. The threads at the
bottom of the insert are being formed and the
insert is mechanically locking the insert into
the base material threads.
13. Continue to rotate the driver installation tool (1) until
the top of the threaded section (2) is level with the
top of the insert (3).
14. Inspect the insert (1) for proper installation (2) into
the tapped hole.
Advertisement
Table of Contents
Troubleshooting
