Te02: Simulation Of Compile Cycles; Brief Description; Function; Requirements - Siemens SINUMERIK 840D sl Function Manual

TE02: Simulation of compile cycles

10.1

Brief description

10.1.1

Function

If part programs, which use compile cycles, are simulated on the SINUMERIK user interface
(e.g. HMI Advanced) simulation is aborted and corresponding error messages are issued.
The reason is that compile cycle support has not yet been implemented on the HMI.
The measures described below show how to set up the simulation runtime environment to
enable the simulation of part programs, which use compile cycles, without error messages.
10.1.2

Requirements

OEM transformations
At least the following software version is required in order to use the functions of OEM
transformations to simulate part programs: SW 6.2.12
Special Functions
Function Manual 09/2011, 6FC5397-2BP40-2BA0
10
451