Condition At Parts Program Start (Cpmstart) - Siemens SINUMERIK 840D sl Function Manual

M3: Coupled axes
5.5 Generic coupling
Constraints
• The coupling characteristics set with CPMRESET is retained until the coupling module is
deleted with (CPDEL).
• For the coupling type (CPSETTYPE="TRAIL", "LEAD", "EG" or "COUP") the response is
defined by the following machine data during RESET:
MD20110 $MC_RESET_MODE_MASK (definition of initial control system settings after
RESET/TP-End)
→ See Section "Defaults" in " Coupling types (CPSETTYPE) [Page 317] ".
5.5.5.12

Condition at parts program start (CPMSTART)

At part program start the coupling can be activated, deactivated or the current status can be
retained. The behavior can be set separately for each coupling module.
Programming
Syntax:
Identifiers:
Functionality:
Value:
300
CPMSTART[FAx]= <value>
Coupling Mode Start
Defines the behavior of a coupling at part program start.
Type: STRING
Range of values:
"NONE" The current state of the coupling is retained.
"ON" When the appropriate coupling module is created, the
coupling is switched on. All defined leading axis
relationships are activated. This is also performed when
all or parts of these leading axis relationships are active,
i.e. resynchronization is performed even with a
completely activated coupling.
"OF" The coupling is switched off. When the relevant coupling
module was created without an explicit definition
(CPDEF), the coupling module is deleted. Otherwise it is
retained, i.e. it can still be used.
"DEL" The coupling is deactivated and then deleted.
Default value: "NONE"
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
Special Functions