Siemens SINUMERIK 840D sl Function Manual page 263

Sample notations
EGONSYNE(A, "FINE", 110, "NTGT", B, 0, 2, 10)
couple A to B, synchronized position A = 110, B = 0, coupling factor 2/10, approach mode =
NTGT
EGONSYNE(A, "FINE", 110, "DCT", B, 0, 2, 10)
couple A to B, synchronized position A = 110, B = 0, coupling factor 2/10, approach mode =
DCT
EGONSYNE(A, "FINE", 110, "NTGT", B, 0, 2, 10, Y, 15, 1, 3)
couple A to B, synchronized position A = 110, B = 0, Y = 15,
Coupling factor to B = 2/10, Coupling factor to Y = 1/3,
approach mode = NTGT
With synchronization
The syntax specified above applies with the following different meanings:
If a curve table is used for a leading axis, then the denominator of the linear coupling of the
coupling factor (N
couplings).
For control, denominator zero is the indicator that the counter of the coupling factor (Z
be interpreted as the number of the curve table to be used. The curve table with the specified
number must already be defined at ? power on (in accordance with Chapter "Curve Tables").
The leading axis specified (LA
factor (linear coupling).
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
) must be set to 0 (denominator 0 would be impermissible for linear
i
) corresponds to the one specified for coupling via coupling
i
M3: Coupled axes
5.4 Electronic gearbox (EG)
) is to
i
263