Block Change Behavior (Cpbc) - Siemens SINUMERIK 840D sl Function Manual

Programming
Syntax:
Identifiers:
Functionality:
Co-ordinate
reference:
Example:
Programming
CPFRS[X2]="BCS"
Constraints
• Co-ordinate reference has to be specified when creating a coupling module, else the
default value is used. It is not possible to effect subsequent changes.
• Simultaneous active transformation and coupling via RESET is not supported.
Solution: Switching off the coupling with CPMRESET="OF" with RESET switching it on
again with CPMSTART="ON" in the part program.
• Simultaneous operation of the previous function "Axial Coupling in the Machine Co-
ordinate System (MCS Coupling)" and the generic coupling is not supported.
• CPFRS is not available in the main run.
5.5.5.4

Block change behavior (CPBC)

The block change criterion can be used to specify under which conditions the block change
with activated coupling is to be permitted in the processing of the part program. The status of
the coupling influences the block change behavior. If the specified condition is not fulfilled, the
block change is disabled. The block change criterion is only evaluated with an active
coupling.
Special Functions
Function Manual, 09/2011, 6FC5397-2BP40-2BA0
CPFRS[FAx]= (<co-ordinate reference>)
Coupling Following Relation System
Defines the co-ordinate reference system for the coupling module of
the following axis/spindle FAx.
Type: STRING
Range of values:
"BCS" Basis Co-ordinate System
"MCS" Machine Coordinate System
Default value: "BCS"
Comment
; The base co-ordinate system is the co-ordinate reference for
the coupling module with following axis X2.
M3: Coupled axes
5.5 Generic coupling
Basic Coordinate System
Machine coordinate
system
289