ABB i-bus
KNX
Commissioning
3.2.5.8.1
Parameter window A: Monitor active power
In parameter window A: Monitor active power, the parameters and the communication objects for the de-
tection and monitoring of the active power of output A are enabled.
Send "Active power" after a change
Options:
•
yes: The value of the communication object Active power is sent after a change. The following para-
meter appears:
Send "Active power" on request
Options:
•
yes: The value of the communication object Active power is sent when a telegram is received on the
communication object Request power values. This communication object is enabled in the parameter
window General, page 29 .
Send "Active power" cyclically
Options:
•
yes: The value of the communication object Active power is sent cyclically. The setting of the cycle
time is undertaken in parameter window General, page 29 (parameter Cycle time for power values).
Cycle time and request objects are set
on "General"
<−−− NOTE
80 2CDC 505 084 D0203 | SE/S 3.16.1
no
yes
Send "Active power" when
+/- W [1...4,600]
Options:
1...5...4,600
This parameter determines which changes of the value of the communication object Active power
are sent.
no
yes
no
yes