ABB i-bus KNX Product Manual page 141


ABB i-bus KNX
Planning and application
Behaviour with:
Staircase lighting
Switching ON and OFF
delay
Flashing
Bus voltage recovery Download
In Parameter window The staircase lighting time
X: Function, you can set if is set to the parameterized
the function Time is value.
disabled or not disabled
If the type of function Time
after bus voltage recovery.
has changed with the
Otherwise, the value in CO download, the following
Switch of the output applies:
determines the behaviour
If the output was switched
of the staircase lighting.
on before download, the
write with 1: staircase lighting time
restarts.
Staircase lighting starts
If the type of function Time
write with 0:
has not changed with the
Staircase lighting switched
download, the following
off
applies:
not write:
If the staircase lighting or
the warning time before
If the staircase lighting or
bus voltage failure was
the warning time before
active, staircase lighting
bus voltage failure was
restarts.
active, staircase lighting
restarts.
The staircase lighting time
changed via the bus is
retained.
In Parameter window Unchanged. Change only
X: Function, you can set if after an event has been
the function Time is received.
disabled or not disabled
after bus voltage recovery.
Otherwise the value in CO
Switch of the output
determines the delay.
write with 1:
Parameterized ON delay
restarts.
write with 0:
Parameterized OFF delay
restarts.
not write:
If a delay was active before
bus voltage failure, this will
restart.
In Parameter window Unchanged. Change only
X: Function, you can set if after an event has been
the function Time is received.
disabled or not disabled
after bus voltage recovery.
Otherwise the value in CO
Switch of the output
determines the behaviour
of flashing.
write with 1:
Flashing with ON restarts.
write with 0:
Flashing with OFF restarts.
not write:
If flashing was active
before bus voltage failure,
this will restart.
ETS reset Full download / applica-
tion update
As with bus voltage In Parameter window
recovery X: Function, you can set if
the function Time is
disabled or not disabled
after bus voltage recovery.
Otherwise, the value in CO
Switch of the output
determines the behaviour
of the staircase lighting.
write with 1:
Staircase lighting starts
write with 0:
Staircase lighting switched
off
not write:
If the staircase lighting or
the warning time before
bus voltage failure was
active, staircase lighting
restarts.
The staircase lighting time
is overwritten with the
parameterized value.
The switch telegram set by As with ETS reset
the communication object
Switch is implemented
without delay.
The switch telegram set by As with ETS reset
the communication object
Switch is implemented
without flashing.
SE/S 3.16.1 | 2CDC 505 084 D0203 139