Parameter Window Frequency - ABB i-bus KNX Product Manual


ABB i-bus KNX
Commissioning
3.2.3.3

Parameter window Frequency

In parameter window Frequency, parameter and communication objects for the detection and monitoring
of the frequency are enabled. The parameter window is enabled when in parameter window Function,
page 35, the parameter Monitor "Frequency" has been selected with the option yes.
Send "Frequency" after a change
Options:
•
yes: The value of the communication object Frequency is sent after a change. The following parame-
ter appears:
Send "Frequency" on request
Options:
•
yes: The value of the communication object Frequency is sent when a telegram is received on the
communication object Request instrument values. This communication object is enabled in the pa-
rameter window General, page 29 (parameter Cycle time for instrument values).
Send "Frequency" cyclically
Options:
•
yes: The communication object Frequency is sent cyclically. The setting of the cycle time is undertak-
en in parameter window General, page 29 (parameter Cycle time for instrument values).
Cycle time and request objects are set
on "General"
<−−− NOTE
44 2CDC 505 084 D0203 | SE/S 3.16.1
no
yes
Send "Frequency" when
+/- 0.1 Hz x value [1...650]
Options: 1...5...650
This parameter determines which changes of the value of the communication object Frequency are
sent.
no
yes
no
yes