ABB i-bus KNX Product Manual page 71


ABB i-bus KNX
Commissioning
Logical connection 2 active
The same programming options exist as those for parameter Logical connection 1 active.
Object "Logical connection 1" after
bus voltage recovery or ETS reset
Options: 1
0
This parameter defines the value allocated to the communication object Logical connection 1 with
bus voltage recovery and ETS reset.
A further parameter appears if GATE is selected with the parameter Function of object "Logical
connection 1":
Gate disabled, if object value
"Logical connection 1" is
Options: 1
0
This parameter defines the value, at which the communication object Logical connection 1
disables the GATE.
Disabling of the gate means that the telegrams received on the Switch communication ob-
ject are ignored. As long as the GATE is activated, the value that was sent last to the input
of the GATE remains on the output. After a gate is blocked, the value that was on the output
before the block remains on the output of the gate.
After the GATE is enabled, this value will be retained until a new value is received.
For further information see: Function chart, page 120
SE/S 3.16.1 | 2CDC 505 084 D0203 69