ABB i-bus
KNX
Commissioning
Copy
The following options can be selected before copying the parameter settings:
•
Leave the group addresses unchanged (if possible) in the target channel
•
Copy group addresses
•
Delete group addresses in the target channel
Exchange
The following options can be selected before exchanging the parameter settings:
•
Retain group addresses
•
Exchange group addresses
•
Delete group addresses
3.2
Parameters
The parameterization of the Energy Actuator is implemented using the Engineering Tool Software ETS
from version ETS3.0f or higher.
The application program is available in the ETS3 at ABB/Output/Energy Actuator.
The following chapter describes the parameters of the device using the parameter window. The parameter
window features a dynamic structure so that further parameters may be enabled depending on the param-
eterization and the function.
The default values of the parameters are underlined, e.g.:
Options:
Note
However, as the functions for all outputs are identical, only the functions of output A will be described.
28 2CDC 505 084 D0203 | SE/S 3.16.1
With this button, copy the settings of the source channel into the target channel or
channels.
With this button, exchange the settings of the source channel with the target channel.
Confirm your selection with this button, and the window closes.
Using this button, the window closes without accepting the changes.
yes
no