ABB i-bus KNX Product Manual page 34


ABB i-bus KNX
Commissioning
Enable communication object
"Request power values" 1 bit
Options:
•
yes: A 1 bit communication object Request power values is enabled.
Via this communication object, all power values can be requested, provided that they have been parame-
terized with the option on request. These power values include:
•
Active power (Output A...C)
•
Active power total
•
Apparent power (Output A...C)
•
Send sum power values
With the option yes, the following parameters appear:
Cycle time for instrument values in s
[0...65,535, 0 = do not send cycl.]
Options:
A common cycle time for all instrument values is set with this parameter, provided that this has been pa-
rameterized with the option Send cyclically.
Cycle time for power values in s
[0...65,535, 0 = do not send cycl.]
Options:
A common cycle time for all power values is set with this parameter, provided that this has been parame-
terized with the option Send cyclically.
32 2CDC 505 084 D0203 | SE/S 3.16.1
no
yes
Request with object value
Options: 0
1
0 or 1
•
0: Sending status messages is requested with the value 0.
•
1: Sending status messages is requested with the value 1.
•
0 or 1: Sending status messages is requested with the value 0 or 1.
0...900...65,535
0...900...65,535