Switch Settings; Figure 2-1 Acuix Pan And Tilt Camera Assembly; Figure 2-2 Location Of Dip And Rotary Switches On Main Board - Honeywell ACUIX User Manual

Switch Settings

Document 800-01023 Rev A
02/08
The ACUIX has two DIP switches (SW5 and SW6) on the pan and tilt printed circuit board
(PCB) for setting the protocol, baud rate, and parity. These settings must match the
control equipment settings.
There are four rotary switches (SW1, SW2, SW3, and SW4) for setting the ACUIX logical
address for control purposes.
A DIP switch can also be used to restore the default settings and another DIP switch to
override the switch settings for the logical address.
Figure 2-1 ACUIX Pan and Tilt Camera Assembly
Printed circuit board
Figure 2-2 Location of DIP and Rotary Switches on Main Board
Rotary switches
SW1, SW2,
SW3, & SW4
ACUIX High Speed Dome User Manual
DIP switches
SW5 and SW6
2
21