Honeywell ACUIX User Manual page 117

Document 800-01023 Rev A
02/08
Program a Mimic Tour
1. Select 2 in the PTZ Mimic Tours menu to program a Tour. Enter a Tour number
(1–16) and press Enter.
2. The ACUIX counts from 120 to 0 seconds. You have 120 seconds to pan and tilt the
ACUIX and adjust the lens zoom setting. The ACUIX saves the PTZ commands
performed during the 120 seconds. When the scan reaches 0, it displays Program
Mimic Tour Complete.
3. To save the Mimic Tour select the ESC (clear/manual) key on the controller when
you are finished programming the Tour. The ACUIX saves the PTZ commands you
entered between the time you started the programming mode until you selected
ESC.
Delete a Mimic Tour
Select 3 in the PTZ Mimic Tours menu to delete a Tour. Enter the Tour number (1–16) and
press Enter.
The display returns to the PTZ Mimic Tour menu. Select another Mimic Tour option or
select ESC to return to the main programming menu.
Program a Preset Tour (Honeywell VCL and Supported 3rd
Party Protocols)
This menu option is only displayed when the ACUIX DIP switches are set to Honeywell
VCL, Pelco P, or Pelco D protocol. When set to Honeywell Standard mode, this option is
NA (not applicable). See
Program Preset
Programming with Honeywell VCL Protocol
Tours using Standard protocol.
1. Position the cursor on 2 in the
Function Programming menu and
press Iris Open to program a Preset
Tour.
2. Use the tilt up function on the joystick
until the desired Preset Tour number
(1–16) displays, then press Iris Open.
3. Move the joystick up, down, left, or
right to move between fields.
ACUIX High Speed Dome User Manual
Tours, page 43, in Chapter 4, Operation and
for more information on programming Preset
Preset Tour Number --
#$ to scroll
Press Iris Open when done
ESC to Exit
Program Preset Tour n
NUM PRESET VELOCITY DWELL
1 -- ---
2 -- ---
3 -- ---
4 -- ---
5 -- ---
6 -- ---
7 -- ---
D = Delete E = Exit S = Save
ESC to Exit
--
--
--
--
--
--
--
117