Troubleshooting
Problem: Lens Out of Optical Focus
Problem: Cannot Find Home or Does Not Go to a Preset
Problem: Pan and Tilt is Jerky
130
1.
Verify the lens cap is not on the camera. A translucent cap may be in place and
could blur the video if not removed.
2.
Send the ACUIX to Preset 98. This pre-programmed Preset resets the camera lens.
3.
This can also be caused by dirt, oil, grease, fingerprints, and so on, that have
accumulated on the lens or lower dome. Check the lens and dome and clean them,
if needed.
Caution
Use extreme caution when cleaning the lens and dome so you do
not scratch their optical surfaces. Prepare a washed-out cotton cloth
or lens cleaning paper with alcohol or lens cleaning liquid. Clean by
moving spirally from the lens center towards its rim. Repeat until
completely clean.
1.
Verify that the pan and tilt rotates freely with no interference from wiring.
2.
Verify the pan and tilt belts are on their associated sprockets and are not loose.
1.
Verify that the pan and tilt rotates freely with no interference from wiring.
2.
Verify both data lines are connected.
3.
A motor may be defective or the wiring to the motor may be broken.