Table 3-7 Still Preset Operation - Honeywell ACUIX User Manual

Operation and Programming with Honeywell Diamond Protocol
42
The ACUIX has a Still Preset feature that can be enabled or disabled through the Camera
Options menu.
Table 3-7 Still Preset Operation
If:
Still Preset is on (video is frozen)
Still Preset is off (video is unfrozen) Video returns to normal operation.
Still Preset
If the camera installed in the ACUIX has the Still Preset feature, and it is set to ON in the
Camera Options menu, the ACUIX freezes the video between Presets. When the ACUIX is
viewing a Preset and receives a command to go to another Preset, the video remains at the
current Preset until the ACUIX arrives at the next Preset and then switches the video to the
new Preset. While traveling between Presets, an asterisk displays to the left of the camera
ID. If Still Preset is set to OFF, the ACUIX displays the actual video as it travels from one
Preset to the next. If turned on and video is recording, this feature saves storage space
List Programmed Presets
A list of the programmed Presets can be viewed for each ACUIX. To view a listing of the
programmed Presets, perform the following steps. This display cannot be edited; it is for
viewing purposes only.
1. Press Dome Menu.
Press + or - until PreShot Menu displays on the controller LCD.
2.
3. Press Enter.
Press + or - until List displays on the controller LCD.
4.
5. Press Enter. A list of the programmed Presets displays on the monitor (where the
ACUIX video can be viewed).
The controller LCD display shows the command Page Down. Press Enter to view
6.
more pages of the listing. When you have reached the end of the listing, End of
Directory displays on the monitor. To go back to the first page of the listing, press
Enter.
7. When you are finished viewing the Preset listing, press Clear/Manual.
8. To exit the menu on the LCD controller, press Dome Menu or press Menu ESC.
Then:
Video is frozen between Presets. Video from the
old position remains until the scan arrives at the
new Preset, then switches to the video from the
new Preset. While video is frozen, an asterisk (*)
appears on the same line as the Camera ID.