Sector Ids; Figure 3-1 Sectors Ids - Honeywell ACUIX User Manual

Sector IDs

Document 800-01023 Rev A
02/08
Sector IDs are used to quickly identify specific areas or scenes an ACUIX is viewing while
an operator is manually controlling the ACUIX. Each ACUIX can be programmed to store
up to 16 sectors. The sectors can overlap. The following diagram shows two Sector IDs.
Figure 3-1 Sectors IDs
Whenever an operator positions the ACUIX to view an area inside Sector 1, the title (for
example, FRONT GATE) of Sector 1 is added to the video signal.
Note The Sector title display must be set to ON to view Sector titles on the monitor.
If the operator positions the ACUIX where one or more programmed sectors overlap, the
ACUIX sequences between the sector titles for 1.5 seconds per sector. The operator
looking at the monitor quickly knows the location the ACUIX is viewing. The location of
the Sector ID title is programmable. See
Chapter 7, On-Screen Setup Menus
Program Sector IDs
1. Press Dome Menu.
Press + or - until Sector/Priv Menu displays on the LCD.
2.
3. Press Enter.
Press + or - until Program displays on the LCD.
4.
5. Press Enter.
6. Enter the desired Sector number (1–16) to program.
7. Press Enter.
8. If desired, enter the Sector title (up to 24 characters):
a. Press + or - until the desired character displays on the LCD screen, and then
press Character Select. The controller sends the character to the ACUIX.
b. Continue selecting characters and pressing Character Select until the desired
title displays on the monitor.
c. Press Enter.
ACUIX High Speed Dome User Manual
Change Sector Name Location, page 91, in
for more information.
49