Figure 2-1 Dip Switch Locations; Table 2-1 Default Dip Switch Settings - Honeywell ACUIX User Manual

Installing the Scan Assembly
4
Figure 2-1 shows the location of the DIP switches (SW1 to SW6) on the scan
assembly circuit board.
Figure 2-1 DIP Switch Locations
Table 2-1 lists the default DIP switch settings.
Table 2-1 Default DIP Switch Settings
Setting
Address
Protocol
Baud rate
Parity
Miscellaneous Defaults*
Restore Factory Defaults
Overriding the Logical
Address
Debugging/boot control
Reserved
* These are advanced switch settings and it is not recommended to make changes to
these defaults. See the System Administration and Equipment Handling
information.
Default Switch
1 SW1, SW2, SW3, and SW4
MAXPRO-mode SW5-1 to SW5-5
9600 SW6-1 to SW6-4
Even SW6-5 SW6-6
OFF SW5-7
ON SW5-8
OFF SW6-7
OFF SW6-8
SW1, SW2, SW3, and SW4
SW5
SW6
Scan assembly
(includes camera)
for more