Function Programming - Honeywell ACUIX User Manual

On-Screen Setup Menus

Function Programming

116
Select Y (yes) to turn Motion Detection on, select N (no) to leave Motion Detection off.
2.
3. Select ESC to exit the menu and return to the Camera Options menu.
If Motion Detection is enabled and motion is detected, the message Motion
Detected is added to the video signal. The message remains on the video until the
ACUIX receives a pan, tilt, or zoom command. Motion detection is automatically
disabled as soon as motion is detected to avoid multiple triggers of motion detection
from the same event. Motion detection is again enabled after a one minute delay of
any Motion Detect Event. If the ACUIX is using IntelliBus protocol, for each Motion
Detect Event an IntelliBus Motion Detect message is sent to the IntelliBus master.
If Motion Detection is enabled and manual Pan/Tilt/Zoom operation is in progress,
Motion Detection is disabled and will re-enable 30 seconds after the PTZ operation
has concluded.
Select 6 in the Main menu to access
additional programming options.
The protocol setting determines the function
programming available to the user. If a
function is not available for a specific
protocol, NA displays next to the number.
Mimic Tour (Honeywell Diamond Protocol Only)
This menu option is only displayed when the ACUIX DIP switches are set to Honeywell
Standard protocol. When set to Honeywell VCL mode, this option is NA (not applicable).
See Programming Mimic Tours, page 71, in
Honeywell VCL Protocol for more information on programming Mimic Tours.
Select 1 in the Function Programming menu
to program, run, or delete a PTZ (pan, tilt,
zoom) Mimic Tour.
Run a Tour
Select 1 in the PTZ Mimic Tours menu to run
a tour. Enter the Tour number (1–16) and
press Enter. If the Tour is programmed, it will
run.
If the Tour is not programmed, the message Does Not Exist appears on the top of the
display.
FUNCTION PROGRAMMING
1 PTZ Mimic Tour Menu
2 Program a Preset Tour
3 Privacy Zone Options
4 List PS/VS/Sectors
5 Program Sector
6 Program Privacy
7 Delete PS/PT/PZ/Sector
ESC to Exit
Chapter 4, Operation and Programming with
PTZ MIMIC TOURS
1 Run a Tour
2 Program a Mimic Tour
3 Delete a Mimic Tour
ESC to Exit