Honeywell Vcl Coax Control Protocol - Honeywell ACUIX User Manual

On-Screen Setup Menus

Honeywell VCL Coax Control Protocol

86
3. With SETUP flashing on the LCD screen, press Aux.
Note If password protection is enabled on the ACUIX, you must log into the ACUIX
with a supervisory password.
When using Honeywell VCL protocol, the following keys are used to navigate within the
on-screen menus:
• Use the direction arrow keys, F1 ( ) F2 ( ) F3 (!) F4 ("), to maneuver through the
menus, along with pressing the corresponding number on the keyboard to enter
sub-menus.
• Once in the setup menu, the Camera and Preset buttons can be used to toggle
through available characters and pressing Aux sends the selected character to the
dome.
• Pressing the Counter key jumps the selection between upper case and lower case
letters. If a symbol character is being displayed when the Counter key is pressed, the
selection jumps to a lower case a.
• Press and hold fn then press Counter to jump to symbol characters when letter
characters are being displayed.
• Press monitor to send BACKSPACE to the dome to delete the previous character.
• Press and hold fn then press monitor to send the space character, which is also
available between Z and a.
• Press wash to send INSERT to the dome to insert a line
• Press wipe to send DELETE to the dome to delete a line.
• Press F5 (enter) to send ENTER to the ACUIX dome menu.
• Press F6 (menu) to send ESC to the ACUIX dome menu.
• Press sequence to send S to the ACUIX dome for saving settings.
• Press Aux in list menus to display the next page of items.
• Press lock to exit OSD and LCD menus and return the dome and keyboard to normal
operation.
• The keyboard also shuts down the menus if there has been no keyboard activity for
over one minute.
If the ACUIX is set to VCL Coax control, the HMAX082/HMAX162 matrix switcher and
HKJMMTP controller is required. Refer to the operation and programming manual for this
system.