Document 800-01023 Rev A
02/08
Caution
Changing these settings can cause loss of communication between
the controller and the ACUIX.
Change Camera Address
1.
Select 1 to change the camera address.
2.
Move the joystick up and down to select
a new camera address (0000–9999).
Move the joystick left or right to move
between digits, if necessary.
Note
Do not go above the limit of the controller as this may result in you losing
control of the dome.
3.
Press Iris Open.
Note
If you change the address of the ACUIX, you must change the control camera
on the controller to match the new address in order to change any other
menu options or control the ACUIX.
Change Protocol
Select 2 to toggle between the available protocol settings: DIAMOND, MAXPRO, VCL 485,
VCL UTC, Pelco P, Pelco D, IBUS, or AD.
Change Baud Rate
Select 3 to toggle between the available baud rate settings: 600, 1200, 2400, 4800, 9600,
19200, 38400, 57600, or 115200.
Change Parity
Select 4 to toggle between the available parity settings: EVEN, ODD, or NONE. A
ACUIX High Speed Dome User Manual
ADDRESS, PROTOCOL CHANGE MENU
Settings Change "ENABLED*
1 Change Camera Address .... 1
2 Change Protocol .... DIAMOND
3 Change Baud Rate ...... 9600
4 Change Parity ......... EVEN
IRIS CLOSE to Exit
101