Mimic Tour Operation; Deleting Privacy Zones, Presets, Preset Tours, And Sectors - Honeywell ACUIX User Manual

Operation and Programming with Honeywell VCL Protocol

Mimic Tour Operation

Deleting Privacy Zones, Presets, Preset Tours, and Sectors

72
Mimic Tours 1–3
Preset commands 80, 81, and 82 are reserved for running Mimic Tours 1, 2, and 3,
respectively. The ACUIX, where the Mimic Tour is stored, must be the control camera on
the system controller. The ACUIX continues to run the Mimic Tour from beginning to end.
Enter a Preset 80 command on the controller to run Mimic Tour 1, enter a Preset 81
command to run Mimic Tour 2 or a Preset 82 command to run Mimic Tour 3.
Mimic Tours 1–16
Preset command 76 is reserved for running Mimic Tours 1–16.
1. Send the ACUIX to Preset 76.
2. Use the joystick tilt up and down function until the desired Mimic Tour number
displays. Use the joystick pan left and right functions to move between the digits, if
necessary.
3. Press Iris Open.
Stop a Mimic Tour
Stop the Mimic Tour by manually controlling the ACUIX or by sending the ACUIX a Preset,
Preset Tour, or another Mimic Tour command.
Note The Iris Open/Close commands will not stop a Mimic Tour.
The programming for Privacy Zones, Presets, Preset Tours, and Sectors can be deleted
using the on-screen setup menus. Existing programming does not have to be deleted to
be reprogrammed. You can simply reprogram the coordinates for an existing Privacy
Zone, Preset, or Sector by following the programming procedures.
1. Press and hold 'Lock', then press 'F6' ('Menu') and then press 'aux' to enter the
ACUIX dome menu.
Press the joystick down until 6 Function Programming is highlighted and then
2.
press Iris Open.