Figure 3-2 Sector Id Coordinates; Table 3-9 Sector Id Commands - Honeywell ACUIX User Manual

Operation and Programming with Honeywell Diamond Protocol
50
The following options are displayed on the monitor:
Table 3-9 Sector ID Commands
Command
E to Edit Sector
D to Delete Sector
S to Save Sector
Coordinates
N to Save Name only
9. Press + or - until the character for the desired action displays on the LCD screen and
then press Character Select. To save Sector coordinates, press + or - until S
displays on the LCD screen and press Character Select. Refer to
programming coordinates.
Figure 3-2 Sector ID Coordinates
Bottom tilt
Left pan
a. Using the joystick, move the ACUIX so the lower left corner of the sector is
centered on the monitor, and then press Enter.
b. Using the joystick, move the ACUIX so the upper right corner of the sector is
centered on the monitor, and then press Enter.
Note If the upper right tilt position is below the lower left tilt position, the message
Illegal Tilt Direction displays. Re-adjust the tilt position until the
message disappears or press Clear/Manual to cancel the operation and
return to manual operation.
10. Repeat step 6 to step 9
return to manual operation.
11. Press Dome Menu or Menu ESC to exit the Dome Menu on the LCD display.
Function
Press + or - key until E displays on the LCD screen and
press Character Select. Repeat
Press + or - key until D displays on the LCD screen and
press Character Select. The Sector number entered in
step 6 is deleted.
Press + or - until S displays on the LCD screen and
press Character Select. Follow the instructions in
step 9 for saving the Sector coordinates.
Press + or - until N displays on the LCD screen and
press Character Select. This option is used for
renaming Sector IDs. Only the title entered in
saved for the Sector number entered. The current
Sector coordinates are not changed.
Right pan
Top tilt
to continue programming Sectors or press Clear/Manual to
step 8.
step 8 is
Figure 3-2 for