Operation And Programming With Honeywell Vcl Protocol; Introduction; Power Up - Honeywell ACUIX User Manual

Operation and Programming with Honeywell
VCL Protocol

Introduction

Power Up

Document 800-01023 Rev A
02/08
This chapter provides specific operation and programming information when the ACUIX
is set to Honeywell VCL protocol. Honeywell recommends using the HJZTP joystick
controller when using this protocol. Operation is the same as described in
Operation and Programming with Honeywell Diamond Protocol
in the following paragraphs. Many of the features and programming options are accessed
by using pre-programmed Preset commands.
Note Although the information in this chapter is specific to the Honeywell VCL
protocol, when the ACUIX is set to MAXPRO, Pelco P or Pelco D protocol, the
ACUIX operates in a similar manner.
The operation of the ACUIX upon power up is the same as described in
Operation and Programming with Honeywell Diamond
ACUIX High Speed Dome User Manual
with the exceptions noted
Chapter 3,
Protocol.
4
Chapter 3,
61