Freeze And Unfreeze Video; Flashback Operation - Honeywell HD6 Series User Manual

6.3 CONTROLLING SCAN ASSEMBLIES, CONTINUED
The White balance can be set to manual mode. If the unit is in manual mode, the red
and blue gain settings can be set between 0 (low) and 255 (high).
6.4

FREEZE AND UNFREEZE VIDEO

When the scan is set for standard Honeywell Diamond protocol, when using the
HJZTP/HJZTPX controller, press and hold the Fn key, then press F2 ( ) or freeze to
toggle the camera between freeze mode on and freeze mode off.
When using the scan in Honeywell Maxpro mode, Honeywell VCL, Pelco P Code, or
Pelco D Code protocol, sending PreShot (View) command 95 invokes the
Freeze/Unfreeze function. If the video is normal, PreShot (View) command 95 freezes
the video. If the video is frozen, PreShot (View) command 95 unfreezes the video.
When the video is frozen, an asterisk displays in the bottom left corner of the display and
the camera remains on the current scene until the operator unfreezes the video. An
operator can manually control the camera or send the camera to a PreShot, but the
video display does not change. When the video is unfrozen, the scene the camera is
viewing is outputted on the video signal.
Refer to your specific controller manual for sending PreShot commands to the HD6.
6.5

FLASHBACK OPERATION

When using an HJZTP controller and scan in standard Honeywell Diamond mode, press
and hold Fn, then press F3 ( ) or press auto 180 to operate the flashback function.
When the HD6 is set for Honeywell Maxpro mode, Honeywell VCL, Pelco P Code, or
Pelco D Code protocol, sending PreShot (View) command 96 invokes the flashback
function.
The flashback function provides the user with the ability to quickly return to a scene of
interest. For example, after the scan has initialized, the operator finds a scene of
interest. If the operator invokes the flashback command, the scan stores the current
scene (Scene A). If the operator moves on to another scene (Scene B), then invokes the
flashback function, the scan returns to Scene A. While at Scene A, if the operator
invokes the flashback function, the scan returns to Scene B. The toggle pattern repeats
indefinitely until the operator moves the scan to a different scene (Scene C). While at
scene C, the operator invokes the flashback command, the scan goes back to the last
scene viewed when the flashback command was invoked. If the flashback command is
invoked again, the scan returns to scene C.
Rev. 1.02 73 900.0679
22-June-2006