PROGRAMMING USING HONEYWELL MAXPRO MODE, HONEYWELL
VCL, PELCO P CODE, OR PELCO D CODE CONTROL SYSTEM
9.1
INTRODUCTION
This section provides information on any differences to the material provided for
standard Honeywell Diamond protocol and provides information specific to operation
with Honeywell Maxpro mode, Honeywell VCL, Pelco P, or Pelco D control systems.
Programming of the unit is the same as described in
statements. The section number corresponds to the numbering in Section 7. Therefore,
Section 9.6 provides additional or replacement information to that in Section 7.6.
9.2
PROGRAMMING PRESHOTS
Refer to your controller's user manual for programming presets or views
9.3
PROGRAMMING VECTORSCANS
VectorScans must be programmed through the setup menu. Send the HD6 to PreShot
90 to access the setup menu. Refer to
9.4
PROGRAMMING SECTOR IDS
Sector IDs cannot be programmed when using a Honeywell Maxpro Mode, Honeywell
VCL, or Pelco control systems.
9.5
PROGRAMMING PRIVACY ZONES
Privacy zones cannot be programmed when using a Honeywell Maxpro Mode,
Honeywell VCL, or Pelco control systems.
Rev. 1.02
SECTION 9:
Section
5.7.2.
101
Section
7, with the following
22-June-2006
900.0679