Scan Installation - Honeywell HD6 Series User Manual

2.4

SCAN INSTALLATION

Ensure that the latches on the HD6 are in the locked position. See
Hold the HD6 scan by the liner mounting bracket, the liner itself, or the latches. DO NOT
HOLD THE HD6 SCAN BY THE CAMERA. Locate the yellow sticker with a black dot in
the center on one of the latches on the scan. Align this sticker with the same sticker in
the housing. This aligns the two wide mounting slots in the scan with the two large
mounting studs in the housing. The HD6 narrow mounting slot aligns with the three small
scan alignment studs in the housing and the wide mounting slot aligns with the two large
scan alignment studs in the housing. The connector on the top of the scan aligns with
the connector in the top of the housing.
Push the HD6 scan into the housing until both latches click into the holes on the
housing. You should hear two clicks. Press firmly on both latches to ensure proper
installation. Gently tug on the scan to verify it is locked in position.
NOTE: The hard ceiling housing is shown. Installation of the HD6 scan in the Dropped
Ceiling, Pendant, and Weather housings is the same. Installation of the lower
dome depends on whether the lanyard is installed at the factory on the lower
dome or on the housing (as shown below). Refer to
depending on your equipment. The lower weather dome is not shown. Refer to
Figure 6
Rev. 1.02
for an illustration of the lower weather dome.
12
Figure 3, Detail A.
Figure 3 or Figure 5
900.0679
22-June-2006