Programming Privacy Zones; Programming Privacy Zones, 18X Color And True/Day Night, 23X Color, And 25X True/Day Night Cameras - Honeywell HD6 Series User Manual

7.4 PROGRAMMING SECTOR IDs, CONTINUED
a. Select Save to program and save sector coordinates. Refer to the diagram for
b. Using the joystick, move the scan so the lower left corner of the sector is
c. Using the joystick on the controller, move the scan so the upper right corner of
8. Repeat steps 4-7 to continue programming sectors or press Esc (F6) to return to
manual operation.
7.5

PROGRAMMING PRIVACY ZONES

All privacy zone programming is password protected. The password is user
programmable up to 14 alphanumeric characters. If the HD6 has an 18x color or 18x
True Day/Night camera, up to 10 (0-9) privacy zones can be programmed with a unique
24-character alphanumeric title. If the HD6 has a 23x Wide Dynamic Range and True
Day/Night camera, 2 privacy zones can be programmed
7.5.1 Programming Privacy Zones, 18x Color and True/Day Night, 23x Color, and 25x
True/Day Night Cameras
To program privacy zones in a HD6 with an 18x camera:
• The HD6 to be programmed must be the control camera on the controller.
• The video from the camera must be viewed on a monitor (to view the programming
menus).
• The operator must have manual control of the Scan.
Note: the following procedure is using an HJZTP controller.
Rev. 1.02
programming coordinates.
Bottom tilt
Left pan
positioned at the center of the monitor, then press Enter (F5). (The crosshair
function may be helpful in determining the center of the monitor.)
the sector is positioned at the center of the monitor, then press Enter (F5). If the
upper right tilt position is below the lower left tilt position, the message "Illegal
Tilt Direction" is displayed. Readjust the tilt position until the message
disappears or press Esc (F6) to cancel the operation and return to manual
operation.
Right pan
Top tilt
89 900.0679
22-June-2006