Defining Protocol (Switches 1-4) - Honeywell HD6 Series User Manual

2.2 RECEIVER BOARD SETTINGS, continued

2.2.1 Defining Protocol (Switches 1-4)

Protocol
Honeywell Diamond
Honeywell VCL
Honeywell Maxpro
Mode
MUX100
AD
Pelco P
Pelco D
Pelco P_AD
Pelco D_AD
Equipment
Javelin equipment
HD6 with an AD1281/1 Code
Distributor
HD6 with a Sennetech Code
Translator, Model SCT-1036
HD6 with the Digital Interface
NOTE: If the switches are set to something other than the above settings, the scan
defaults to Honeywell Diamond protocol.
The standard Pelco P and D selections use special PreShots numbered in
the 80's and 90's. The Pelco P w/AD PreShots and the Pelco D w/AD
PreShots selections set the protocol for Pelco P and Pelco D code
respectively, but use special PreShot numbers less than 32 for HD6 menus
and setup.
Rev. 1.02
1 2
OFF OFF
ON OFF
ON OFF
OFF ON
ON ON
OFF OFF
OFF ON
OFF OFF
OFF ON
Set the Javelin controller for Diamond protocol and
set the HD6 unit for Honeywell Maxpro Mode
protocol.
Set the HD6 to American Dynamics protocol.
Set the HD6 to Honeywell Maxpro Mode protocol.
Set the HD6 protocol to Honeywell VCL if using with
Honeywell's DVM Digital Video Manager. Set the
HD6 to standard (Honeywell Diamond) protocol
when controlling the dome with a web browser.
7
3 4
OFF OFF
ON OFF
OFF OFF
OFF OFF
OFF OFF
ON OFF
ON OFF
ON ON
ON ON
Protocol
900.0679
22-June-2006