List Contents Of A Vectorscan; Run Vectorscan Once - Honeywell HD6 Series User Manual

6.7.2 List Contents of a VectorScan

The contents of each VectorScan stored in the scan can be viewed. The VectorScan
contents cannot be edited from this display. The list displays the PreShots with the
programmed transit times and dwell times in the order they were programmed.
If using an HJZTP controller, perform the following procedure to view the contents of a
VectorScan (stored in the control camera displayed on the programming controller).
1. Press and hold lock, then press F6 (menu). The LCD displays the menu selections
available. Setup will be flashing to indicate that Setup is the currently selected
option.
2. Move the joystick left and right or F3 ( ) and F4 ( ) or camera (left) and preset
(right) keys until VECT is flashing, and then press the aux key.
3. Move the joystick right until VIEW is flashing and then press the aux key.
4. Press Enter (F5) to exit the display.
5. Press the lock key when to exit the menu on the controller LCD.

6.7.3 Run VectorScan Once

If using an HJZTP controller, perform the following procedure.
1. Press and hold lock, then press F6 (menu). The LCD displays the menu selections
available. Setup will be flashing to indicate that Setup is the currently selected
option.
2. Move the joystick left or right or press F3 ( ) and F4 ( ) or camera (left) and preset
(right) keys until VECT is flashing, and then press the aux key.
3. Move the joystick left or right until ONE is flashing and press the aux key.
4. Enter the VectorScan# (0-9) and press Enter (F5). The programmed VectorScan
runs through each programmed PreShot and stops.
5. Press Lock to exit the menus on the controller LCD.
Rev. 1.02 77 900.0679
22-June-2006