Configuring Video Settings; Mode; Figure 32 Mode Tab 1; Figure 33 Mode Tab 2 - Honeywell 30 Series Manual

time. By default, the start and end time of day mode are set to 07:00 and 18:00.
Sensitivity of IR: Adjust the responsiveness of the IR filter to lighting conditions as Low,
Normal, or High.

Configuring Video Settings

Go to Setup  Camera Setup  Video.
This section describes how to configure viewing window and video streaming properties
(format, resolution, frame rate, bit rate, I-frame interval and so on.).

Mode

Go to Setup  Camera Setup  Video  MODE.
In MODE tab, you can set the pixel mode for different cameras.
Changing the video mode will clear the following settings: privacy mask, exposure
Note:
widow, motion and focus window.

Figure 32 Mode Tab 1

4-Megapixel (Max Resolution 2688x1520): Select it and the maximum resolution will
be 2688x1520. The aspect ratio will be 16:9. This mode applies to
HC30W45R3/HC30W45R2/HC30WB5R1/HC30WB5R2/HC30WE5R3/
HC30WE5R2/HC30W25R3/HC30W25R3-12V cameras (see
5-Megapixel (Max Resolution 2560x1920): Select it and the maximum resolution will
be 2560x1920. The aspect ratio will be 4:3. This mode applies to
HC30W45R3/HC30W45R2/HC30WB5R1/HC30WB5R2/HC30WE5R3/
HC30WE5R2/HC30W25R3/HC30W25R3-12V cameras (see

Figure 33 Mode Tab 2

Fisheye (Max Resolution 1920x1920): Select it and the maximum resolution will be
1920x1080. This mode applies to HC30WF5R1 cameras (see
Honeywell 30 Series IP Cameras User Guide
Figure 32).
Figure 32).
Figure 33).
27