Honeywell HD6 Series User Manual page 82

5.9 FUNCTION PROGRAMMING, CONTINUED
1. Run a Tour – Select 1 to run a tour.
Enter the tour number (1-3) and press
Enter (F5 on HJZTP controller).
If the tour is programmed, it will run.
If the tour is not programmed, the
message "Does Not Exist" appears on
the top of the display.
2. Program a Tour – Select 2 to program a
tour. Enter a tour number (1-3) and
press Enter (F5 on HJZTP controller).
The scan counts from 120 to 0 seconds.
You have 120 seconds to pan and tilt
the scan and adjust the lens zoom
setting. The scan saves the PTZ
commands performed during the 120
seconds. When the scan reaches 0, it
displays PTZ Tour Complete.
To program a tour less than 120 seconds, select the Esc key on the controller (F6
on the HJZTP controller) when finished programming the tour. The scan saves the
PTZ commands you entered between the time you started the programming mode
until you selected Esc.
3. Delete a Tour – Select 3 to delete a
tour. Enter the tour number (1-3) and
press Enter (F5 on the HJZTP
controller).
The display returns to the PTZ Tour
Menu. Select another PTZ tour option
or select Esc (F6 on the HJZTP
controller) to return to the main
programming menu.
Rev. 1.02
1. Run a tour
2. Program a tour
3. Delete a Tour
ESC to Exit
Run Tour No. ___
Press 'ENTER' When Done.
Program Tour No. ___
Press 'ENTER' When Done..
Delete Tour No. ___
Press 'ENTER' When Done.
68
PTZ Tours
PTZ Tours
PTZ Tours
PTZ Tours
900.0679
22-June-2006