2.3
VIDEO BOARD
Jumper W8 on the video board enables or disables the 12V auxiliary power provided to
the Interface Board installed in the housing. 12V power is required if the Unshielded
Twisted Pair (UTP) option is installed in the housing. Set jumper W8 on the video board,
part number 519539-1020 (NTSC) or 519539-2020 (PAL), as shown in
For the UTP option, the housing must have the UTP interface board, part number
518753-1030.
BLACK
JUMPER
W8
Figure 2: Video Board, Part Number 519539-1020 (NTSC)
Rev. 1.02
CAUTION: The black jumper must be on pin 1 of W8
for standard interface boards or equipment damage
may occur.
CONNECTOR P10
FROM SCAN WIRING
HARNESS
11
Figure
CAUTION
FOR STANDARD HD6 UNITS
BLACK JUMPER AND
CONNECTOR P10 MUST BE
ON W8 AS SHOWN.
UTP OPTION
REMOVE AND DISCARD
BLACK JUMPER.
CONNECTOR P10
FROM SCAN WIRING
HARNESS
W8
2.
900.0679
22-June-2006